PLANET ECLIPSE: PAL SYSTEM USER MANUAL / ENGLISH
PAL SYSTEM
02 QUICK START
ATTACHING THE PAL LOADER
When attaching the PAL loader system to the PAL enabled marker, ensure the plunger A is aligned correctly and sits under the plunger receiver B . The PAL loader must be pushed fully into the feedtube.
IMPORTANT! If the PAL loader is too tight or too loose simply adjust the PAL clamping feedneck lever and/or feedneck screws C to compensate. IMPORTANT! If the PAL loader is not correctly aligned this could affect the efficiency of the PAL loader system.
03 QUICK START
FIG-1 To assist with alignment, the dimple at the rear of the PAL loader A should sit in the alignment notch at the rear of the PAL feedtube B .
Extracted from the PDF. Read the full manual above, or download it.