Etha EMC Rail Mounting kit Installation Consignment ID
Official use
EMC0001-v1-EN © 2012 Copyright Planet Eclipse Ltd. Eclipse, Planet Eclipse, the Estar Logo Device, Ego, Geo, Etek, Etha and EMC are all either design trademarks, registered trademarks or trademarks of Planet Eclipse Ltd. All other trademarks are property of their respective owners.
Kit contents
1x Etha EMC Shell Right
1x Etha EMC Shell Left
Note: contents may vary
1x Etha EMC Eye Cover Right
1x Etha EMC Eye Cover Left
2x Stock Lever
1x Blanking Plug
Warning!
12x 6-32 UNC x 0.5” Buttonhead Screws (2 Spare)
1x 020 NBR70 O-Ring
If you plan on using any 3rd party bolt on rail sections in the 2, 3, 4 and 8, 9, 10 clock positions on the rail kit, These need to be installed before attaching the Etha EMC shells to the Planet Eclipse Etha.
Unscrew and remove the left and right eye covers using a 5/64” hex key.
1x Stock Adaptor Left
De-gas your marker, discharging any stored gas in a safe direction, and remove the barrel,loader,air system and any paintballs to make the marker easier and safer to work on. Improper installation, misuse, illegal use or modification of this product or any attached 3rd party products may result in serious injury or death. Make sure to fully clean any paint residue from your rail kit immediately after use to avoid potential damage to the surface finish.
1x Stock Adaptor Right
Place the left shell onto the Etha body. Locating it correctly using the mounting points on the side of the body and inside the left shell.
Insert the Stock Lever into the left shell. (It does not matter if the Stock Lever is inserted in the open or closed position).
Place the right shell onto the body ensuring the locating pins and holes are aligned along with the mounting points before pushing the two shells together.
STEP 5 It is recommended that the screws which clamp the two shells onto the body are tightened in a certain order with a 5/64” hex key. The screws numbered 1 2 and 3 as shown left should be inserted first (NOTE Your kit contains 2 spare screws): DO NOT over tighten the screws or you may damage the screws & shells!
- screw half way in
- screw in fully
Now the remaining 7 screws can be screwed in fully one at a time. Keep the remaining 2 spare screws in your kit bag.
Starting on the left side. Ensure the BBSS unit and rubber detent are correctly seated in the Etha body. Insert the EMC Rail Eye Cover into the body and screw in the original eye cover screw with a 5/64” hex key. Then repeat step on right side.
Stock installation
Pull open the stock lever using a finger or appropriate sized hex key placed inside the stock lever.
Insert either the EMC Blanking Plug or the EMC stock adaptor with compatible stock.
Close the stock lever. It will click into the Shells when it is fully closed.
(See stock installation Below for more info)
Note The EMC Stock adaptor accepts most BT-4TM/Model-98TM Adjustable CAR Style stocks. Some 3rd party BT-4TM/Model-98TM style stocks may not fit perfectly in the EMC Rail System adaptor and some modification may be required to achieve a tight fit. We suggest using a thin layer of electrical tape or similar on the grooved section of the stock to ensure a tight fit in the adaptor.
The adaptor comprises of a left and right half. Push these two parts together around the grooved end of the stock. Next fit the large 020 NBR70 o-ring over the adaptors seating it in the middle groove. The stock can now be fitted to the EMC Rail Kit.
Insert your EMC compatible stock.
Extracted from the PDF. Read the full manual above, or download it.