The Ego 11 DART Kit is ONLY compatible with the Ego11 and Eclipse CSL markers. ALL three DART components MUST be used together for the kit to function properly. De-gas your marker, discharging any stored gas in a safe direction, and remove the barrel,loader,air system and any paintballs to make the marker easier and safer to work on
Installing the DART Bolt Pull the bolt pin upwards so that it disengages the rammer and slide the
Installing the DART Valve Guide and Exhaust Valve: Referring to the information
pin must be half way between the fully up (disengaged) and fully down
Valve and Valve Guide, replacing them with the DART equivalents.
bolt out from the rear of the marker. Push the pin back down half way. The
on pages 65-67 of the Ego11 Operators Manual, remove your existing Exhaust
(engaged) position. Important: Place your hand or thumb over the back of
the bolt, or point the back of the bolt towards the ground or into a receptacle
KIT Includes
before proceeding. Rotate the bolt pin through 180 degrees so that the
plunger cannot retain the bolt pin and pull the bolt pin upwards and out of
1 DART Bolt
spring falling out prematurely. Remove the plunger and the spring from the
2 DART Exhaust Valve
the bolt, making sure to cover the back of the bolt to prevent the plunger and Bolt. Place the bolt spring inside the access hole at the rear of the DART
3 DART Valve Guide
bolt and drop a plunger onto of it so that the spring sits inside the body of
the plunger. Using a 1/8th hex key push the plunger sufficiently so that the
spring is compressed and the bolt pin can be installed by pushing it into
the hole at the top of the DART bolt, until it comes to rest against the hex
key. Whilst retaining pressure upon the top of the bolt pin, slide out the hex key. The bolt pin should slide completely through the bolt as the hex key is
removed. When installing the pin, you should hear it “click” into place. If this does not happen ensure that the bolt pin is facing the correct way so that
the slot in the pin engages the plunger and locks the pin correctly in place. Rotate the pin as necessary to ensure this happens. Noting the position of
the Rammer Shaft in the marker body, replace the DART Bolt and locate the bolt pin into the designated groove in the rammer shaft. Installation of your
DART Bolt is now complete.
© Copyright 2012 - Planet Eclipse Ltd. Eclipse and the Estar Logo Device are all either design trademarks, registered trademarks or trademarks of Planet Eclipse Ltd. All other trademarks are property of their respective owners.
Extracted from the PDF. Read the full manual above, or download it.