If your X-RAY® Lens comes into contact with any of these types of substances or chemical fumes, DO NOT USE! Replace with a new Lens for your protection and discard the old Lens immediately. NEVER TAKE CHANCES! B. Always clean your goggle and Lens with a microfiber cloth after every use. Take you goggle system apart bty removing the Lens from the Goggle Frame. Wash any paint residue from the Lens, the Goggle Frame, and inside the Lens Channel within the Goggle Frame with PLAIN WATER. Always wash each piece individually, even if you think it is clean. Always wash and dry each piece of your system completely prior to reassembly and use. Never allow any paint or paint spray to remain on your goggle system overnight. Single Lens: Take your Single Lens out of the Goggle Frame and wash it with PLAIN WATER only. You can dry your Lens with a microfiber or soft cloth. Never use paper towels, newspaper or an abrasive cloth. Polycarbonate scratches easily. Be careful when handling your Lens. Thermal Lens: Take your Thermal Lens out of the Goggle Frame and wash it with PLAIN WATER only. You can dry your Lens with a microfiber or soft cloth. Never use paper towels, newspaper or an abrasive cloth. Polycarbonate scratches easily. Be careful when handling your Lens. Never submerge the Dual Pane Lens under water! Never rub the soft inner lens surface or apply any form of fog resistant solution to this side of the lens. C. Use only an approved Anti-fog Lens Cleaning solution. Never use any other cleaning solutions as they may contain chemicals which will damage the Lens. Spray the exterior of the Lens only and let stand for 15 seconds, then buff dry with a light circular motion using a microfiber or soft cloth. Do not over-buff the Lens, as it will remove the anti-fog coating.
*READ OWNER’S MANUAL BEFORE USING* CAUTION! READ AND FOLLOW THE INSTRUCTIONS EXACTLY FOR ALL CARE AND CLEANING OF X-RAY® GOGGLE LENSES. IF YOU DO NOT FULLY UNDERSTAND OR HAVE ANY QUESTIONS REGARDING THESE INSTRUCTIONS, CONTACT PAINTBALL SOLUTIONS AT 800-724-6822 OR AT [email protected], OR VISIT WWW.PAINTBALLSOLUTIONS.COM.
NO GOGGLE SYSTEM CAN PREVENT FOGGIN UNDER ALL CONDITIONS. IF YOUR GOGGLE DOES FOG DO NOT REMOVE IT WHILE ON THE FIELD. X-RAY® Lenses are made of high-grade polycarbonate, the strongest optical material available. IMPORTANT! Your goggle Lens will deteriorate, weaken, and possibly break if you do not clean them exactly as instructed EVERY TIME THAY ARE USED! FOLLOW THESE INSTRUCTIONS CAREFULLY AND COMPLETELY! Proper cleaning is the only way to keep X-RAY® Lenses strong and resistant to paintball impacts. CLEANING WARNING! Never use cleaners such as Windex®, Fantastic®, Mr. Clean®, Spray 409®, or any product with ammonia. Avoid contact with Gasoline, Acetone, Nail polish Remover, Kerosene, etc. These strong chemicals will weaken the Lens and cause it to fail and/or break.
A. Always clean your X-RAY® Lenses with PLAIN WATER or a paintball approved Anti-Fog Lens cleaning solution. NEVER USE ANYTHING ELSE!
D. Always store your X-RAY® goggle system in a cool, dry place. Never store your goggle system near chemicals or fumes. Gasoline fumes and common cleaning solutions will damage your X-RAY® goggle system and lenses. Replace any X-RAY® lens that has been exposed to these conditions. Never store in a hot place such as a car trunk, near a heater or any heat source. High temperatures will damage your X-RAY® goggles and lenses. E. Always inspect your goggles and lenses for damage prior to and after each game you play and replace as required. Never play with a lens that shows any signs of damage including, but not limited to, cracking, pitting, or deep scratches. F. Always immediately replace any X-RAY® lens that has been shot by a marker at a range of 10 feet or less. (Even if you cannot see any damage). G. Always replace each X-RAY® lens at least once per year even if you have not used them. CAUTION! Improper installation of Facemasks, Lenses or Straps can cause a serious eye injury. Follow all installation instructions closely. Use only X-RAY® Goggle Frames with X-RAY® Facemasks, Lenses or Straps. Never use the X-RAY® Goggle without the Facemask. Make certain the Facemask is properly installed and securely attached to the goggle. Always wear ear protection when playing paintball. Goggle straps are not ear protectors. X-RAY® Goggle System has been specifically designed to be used in the sport of paintball. Like all sports, Paintball has intrinsic hazards. These hazards include being hit by paintballs. Protective equipment cannot eliminate all injuries but will substantially reduce their severity and frequency. Participation in the sport of paintball by a player implies acceptance of the risk of injury. The goal of protective equipment is to minimize the risk of injury.
X-RAY® GOGGLE FIT Goggles must fit properly to provide the best protection. Proper fit requires: 1. Tightening the Strap to hold the goggle system firmly in place on your head 2. Making certain the goggle seals around the face IMPORTANT! The X-RAY® goggle system has a strap, which allows variations in the head size and fit. The plastic slide for adjusting the Strap can be positioned outside or inside the mask assembly for proper fit. To move the two adjustment slides inside the mask assembly, simply turn and slide the Straps out of the mask strap channels. (Fig. A) This is recommended for users under the age of 18. To move the two strap adjustment slides outside the mask assembly, turn and slide the Straps into the mask strap channels. (Fig. B) Adjust the slides as needed. VISOR ATTACHMENT Figures 1-2 A. Wet the ends of the visor attachment posts. B. Push the right-hand post through the correct mounting hole in the mask. C. Push the left-hand post through the correct mounting hole in the mask. D. Rotate the visor so that the center post can be pushed through the mounting hole in the front of the mask.
The first 997 words, extracted from the PDF. Read the full manual above, or download it.