Spyder 2009 Xtra Manual - English

XTRA SCHEMATIC

WARRANTY STATEMENT

English IMPORTANT SAFETY GUIDELINES

WARNING •

This paintball marker is NOT a toy. It can cause serious injury or death.

Kingman recommends that the customer be at least 18 years of age to purchase this product.

Read this manual and air tank warnings before using this product.

Any modifications or tampering of original factory parts will void all warranties and liabilities from Kingman.

Kingman recommends using a barrel blocking device when the marker is not in operation.

To ensure proper adjustment of velocity (fps), Kingman strongly recommends using a chronograph for paintball use located at most paintball stores and paintball fields.

Before and after each use of the paintball marker, check and make sure all screws are securely tightened. Loose screws may prevent the marker from functioning properly. A paintball marker NOT properly maintained can be dangerous and cause injury or death. Consult with the field operator or a qualified safety official at the paintball facility you are playing at.

WARNING: Always keep the marker powered OFF or on SAFE until you are ready to fire. 1. 2.

Kingman STRONGLY recommends that any person using this product or within range of this product while it is in use MUST wear EYE/FACE PROTECTION designed specifically for the sport of paintball. This includes, but is not limited to, performing a maintenance check and during

target practice. •

Kingman reminds the user that it is YOUR RESPONSIBILITY to protect your eyes/face at all

times, and will not be held liable for injuries sustained when failing to wear the appropriate protection. •

Never shoot or point your marker at a person that is not in a designated paintball facility and without proper paintball protection.

Treat every paintball marker as if it were loaded.

Never look down the barrel of a loaded or unloaded marker.

Always keep the paintball marker in SAFE or OFF mode until ready to operate.

Always remove the gas source before disassembly.

Fire only 0.68 caliber paintballs with this product.

Always make certain the bolt is in the un-cocked position when marker is not in use.

Using a paintball marker outside of a non designated paintball field can be illegal, and is subject to law enforcement penalties if property damage is caused by the user.

Never point or shoot your marker at an animal.

Transfer this instruction manual upon change of marker ownership.

Always attach a barrel blocking device over the tip of the barrel for safety precautions when the marker is not in use. Kingman recommends having the marker in the “SAFE” position before use. To operate, push the safety button from the “PUSH SAFE” side of the trigger frame. This will position the marker in a lock safe mode. To disengage the safety button in a safely manner, point the marker in a safe direction, and push the safety button towards the “PUSH FIRE” side of the trigger frame. Place the barrel plug or barrel blocking device over the barrel for safety precaution when the marker is not in use. Attach the CO2 / Compressed air tank to the C/A Adapter. HELPFUL TIP: Make sure to have the CO2 / Compressed air tank filled before attaching. Tighten the tank clockwise in the markers C/A Adapter until it is snug. If an air leak occurs between the tank and the C/A Adapter, replace with a urethane bottle o-ring. NOTE: O-rings in the markers parts kit are not supplied to attach with a CO2 / Compressed Air Tank. IMPORTANT: You should never need to use any hand tool to attach a CO2 / Compressed Air Tank to the C/A Adapter. Attach the elbow and a paintball loader to the markers feed neck. NOTE: Fill your paintball loader with only .68 caliber paint. Cocking the marker. Pull the Top Cocking Knob rearward until the Delrin Bolt latches. CAUTION: Should you let go of the Top Cocking Knob before it latches, your marker may fire. Remove barrel plug or barrel blocking device over the barrel. CAUTION: With the safety button released in the FIRE position the marker is LIVE. By pulling the trigger will fire a paintball. IMPORTANT: In a safe direction or in a designated playing field should you only test the markers capability. Performing a velocity (fps) check. Turning the Velocity Adjuster & Spring Guide clockwise will increase the velocity (fps). Counter-clockwise will decrease the velocity (fps). NOTE: Your marker is intended to be used in a paintball facility with the proper paintball protection. IMPORTANT: Kingman recommends using a chronograph to ensure the marker’s Velocity is under 300 (fps). Detach the paintball loader and all paintballs from the marker. When finished playing remove the paintball loader and vertical elbow from the marker. CAUTION: There may be a paintball in the markers breach; take a couple of shots in a safe direction to make sure the barrel and Receiver are empty. Place the barrel plug or barrel blocking device over the barrel for safety precaution when the marker is not in use. This will help avoid any accidental discharge. Kingman recommends having the marker in the “SAFE” position after use. Unscrew the CO2 / Compressed air tank from the markers C/A Adapter. By turning the tank counter-clockwise will detach from the markers C/A Adapter. CAUTION: Never expose any skin underneath the C/A Adapters bleed hole when removing the tank. This can run the risk of getting skin burn from the releasing of the GAS. IMPORTANT: You should never need to use any hand tool to detach a CO2 / Compressed Air Tank. Store the marker in a paintball bag or in a safe place. WARNING: Before / after use of the marker, make sure to fasten all Screws.…