The Safety is a small mechanical slide on the left side of the marker above the trigger. When the Safety is “Off,” a red color is visible on the marker. The trigger can still be pulled if the Safety is “On,” but the marker will not fire or de-cock.
E-KAST OPERATOR’S MANUAL JT Paintball reserves the right to modify or change its markers without incurring any obligation to incorporate such modifications or changes in any of its products that were sold prior to the modification. The information in this operator’s manual may be updated or changed without notice. This operator’s manual is intended to remain with the paintball marker upon any subsequent transfer of the marker, whether through sale, resale, or furnishing in any manner. An updated or replacement operator’s manual may be obtained from Paintball Solutions at 800-220-3222 or at www.paintballsolutions.com: Questions about the operation of the E-KAST paintball marker may be directed to Paintball Solutions or visit www.paintballsolutions.com for updates regarding your JT Paintball purchase.
5. Turn on the marker by pressing Power Button, located on the back of the grip. (See below for more information) 6. Squeeze the trigger with an even pressure. The cocking pin will snap forward into the un-cocked position. 7. Cock the marker. 8. Follow safety rules for handling compressed gas/air. If any leak occurs in the marker, refer to troubleshooting guide or to a qualified airsmith. Use only cylinders for compressed gas or air that comply with all applicable laws and regulations, including but not limited to those of the U.S. Department of Transportation, OSHA, Compressed Gas Association, and/or American Society for Testing and Materials.
PAINTBALL BASIC SAFETY RULES WARNING THE E-KAST PAINTBALL MARKER IS NOT A TOY. MISUSE MAY CAUSE SERIOUS INJURY OR DEATH. EYE PROTECTION DESIGNED FOR PAINTBALL USE MUST BE WORN BY THE USER AND ANY PERSON WITHIN RANGE. READ THIS OPERATOR’S MANUAL COMPLETELY BEFORE LOADING, PRESSURIZING, OR OPERATING THE JT PAINTBALL E-KAST PAINTBALL MARKER. • Always wear protective goggles and headgear specifically designed for paintball when shooting this or any paintball marker. • Every person within range of an area where a paintball marker is in use must wear protective goggles and headgear specifically designed for paintball. • Always turn the Power OFF and place the Safety ON when not using the marker. • Operate a paintball marker only in areas where it is safe and lawful to do so. • During game play, follow referee’s instructions and all field safety rules. Avoid shooting at a player’s head, neck, or groin area. • Play paintball only where the rules of safe paintball play are followed. • All paintball markers must be chronographed regularly. Adjust marker to shoot paintballs at a velocity less than 300 feet per second (fps) (91.44 m/s) and/or that does not exceed the velocity limit set by the paintball park, where the marker is in use. Chronograph the marker at regular intervals during the day, as well as any time the air source is refilled or changed, any time the barrel is changed, and upon request of any player or game official. • There is always a chance that a paintball is lodged in the barrel of the marker even when it is not visible in the chamber. To check if the marker is unloaded: remove air system and shoot marker in a safe direction. Remove hopper, visually inspect chamber for a paintball, remove and inspect barrel for the presence of a paintball. Never look down the barrel of any paintball marker once the barrel is screwed into the marker. • Markers with regulators hold pressure even after tank is removed. Shoot marker in a safe direction after tank is removed to de-gas it completely.
Bottomline: First check the tank O-ring for rips or tears, then attach the air source by screwing the threads of the tank or air source adapter into the threaded bottom line ASA at the base of the grip. Make sure marker is cocked before attaching air. If leaks occur, recheck tank O-ring. If damaged, replace.
PAINTBALL BASIC SAFETY RULES • This paintball marker operates using compressed gas or air at specified pressure ranges. Follow safety procedures when handling compressed gas or air. All filling of compressed gas or air cylinders must be done by qualified persons. • Always cock marker before attaching air or gas source to it. Failure to always cock marker before attaching air to it may cause accidental firing or discharge of paintballs. • Follow the rules of safe marker handling: Keep finger off trigger until ready to shoot. Keep muzzle pointed in a safe direction. In addition, firmly insert a barrel plug or barrel bag into the muzzle and push the electronic or mechanical safety “on” when the marker is not in use and when in any non-shooting area. • Paintball markers with electronic frames have extremely sensitive triggers. Take extra safety precautions anytime handling or shooting an electronic paintball marker. To avoid accidentally firing the marker, keep the marker off until you are ready to fire. • Never shoot at domestic animals or wildlife. • Never mark objects outside the confines of the game or authorized shooting areas. • Never look down the barrel of the marker. • Never aim or shoot a paintball marker (loaded or unloaded) toward any person who is not wearing protective goggles and headgear specifically designed for paintball. • Before disassembly, storage, or transport of the marker, remove all paintballs from the marker, barrel, and loader; remove air source; and remove all gas or air from the marker. Insert barrel plug and put me chanical safety in “no shoot” position. • Carry marker in case or sturdy bag when in public. • Safely and securely store marker to prevent access to it by unauthorized persons.
COMPRESSED GAS/AIR Do not leave cylinder or pressurized marker in direct sunlight or exposed to heat source. Increased temperature will increase the pressure of compressed gas or air to dangerous levels. E-KAST…
The first 997 words, extracted from the PDF. Read the full manual above, or download it.