R e l o a d e r
Thank you for purchasing your new Empire Reloader B Sound-Activated 3-Speed Paintball Hopper! Should you require any technical assistance on the use of this product, or if your product needs servicing, DO NOT RETURN THE PRODUCT TO WHERE IT WAS PURCHASED. CONTACT: Paintball Solutions 570 Mantua Blvd. Sewell NJ 08080 (800) 220-3222 http://www.paintballsolutions.com
Battery Installation
Remove the bolt holding the battery door. Remove the battery holder. Install batteries following the polarity markings of the holder. Connect power plug to battery pack. Re-install pack. Finally Re-install battery door bolt. The Reloader B comes with both a 4 AA battery pack with spacer and a 6 AA battery pack. The 6 AA batteries will last longer than using 4 AA batteries, but is slightly heavier. We suggest trying the 4 AA battery pack first. If you find that the loader is not performing fast enough after you have set the speed to the highest setting, (see page 2 for “Setting the speed”), or that your batteries are not lasting long enough for the amount of paintballs you are shooting, then switch to the 6 AA battery pack. Care needs to be taken when putting the battery holder into your loader. The wiring must run beside the battery holder and not underneath or on top of it, or you will break your battery cover. When you put your battery cover onto the body, it should slide on smoothly with no pressure required to align the retaining screw. If you have to hold the cover in place while inserting the screw, the wires are positioned incorrectly. Reposition the battery pack u n t i l t h e c o v e r goes on as a precision fit and sits easily and smoothly in the proper location.
Tape batteries for rough play.
Wires should be routed as shown above.
Extracted from the PDF. Read the full manual above, or download it.