This is not a toy. Misuse may cause serious injury or death. Eye protection designed specifically for paintball must be worn by the user and persons within range. Recommend 18 years of age or older to purchase. Persons under 18 years of age must have adult supervision. READ THIS MANUAL BEFORE USING.
TABLE OF CONTENTS
1. RULES FOR SAFE MARKER HANDLING PG. 3
2. SPECIFICATIONS AND FEATURES PG. 3
3. GETTING STARTED PG. 3
4. GENERAL MAINTENANCE PG. 4
5. PROGRAMMING MODE PG. 5
6. DIAGRAM AND PARTS PG. 7
WARRANTY INFORMATION PG. 8
1. RULES FOR SAFE MARKER HANDLING
3. GETTING STARTED
• Treat every marker as if it were loaded. • Never look down the barrel of a paintball marker. • Keep your finger off the trigger until ready to shoot. • Never point the marker at anything you don’t wish to shoot. • Keep the marker on “SAFE” until ready to shoot. • Keep the barrel-blocking device in/on the marker’s muzzle when not shooting. • Always remove paintballs and propellant source before disassembly. • After removing propellant source, point marker in safe direction and discharge until marker is degassed. • Store the marker unloaded and degassed in a secure place. • Follow warnings listed on propellant source for handling and storage. • Do not shoot at fragile objects such as windows. • Every person within range must wear eye, face, and ear protection designed specifically to stop paintballs and meeting ASTM standard F1776. • Always measure your marker’s velocity before playing paintball and never shoot at velocities in excess of 91.44 meters (300 feet-per-second).
Rip-Clip Setup The Rip-Clip™ comes with 2 different adapter plates and 2 different length rail locking screw sets for use on TM-7, TM-15, BT-4 Combat series, BT-4 Slice series, Omega v1 and JT Tactical markers. • For BT-4 Combat and BT-4 Slice series markers, Omega v1 and JT Tactical, use the shorter screws to attach the Rip-Clip™ to the paintball marker. • For the TM-7 and TM-15 Series markers, use the longer screws to attach the Rip-Clip to the paintball marker.
- Select the adapter plate for your marker; they are labeled either TM-15 or TM-7. Do not
use any of the adapter plates for the BT-4 series or Omega/Tactical markers. • Put both screws with thumb nuts attached into the Picatinny rail locking arm. • Place the correct adapter onto the Rip-Clip body if needed. • Install the rail locking arm with screws and thumb nuts onto the Rip-Clip body using a flathead screwdriver (Fig. A). • Make sure the screws are fully seated into the body.
*FULLY READ OWNER’S MANUAL BEFORE USING.
2. SPECIFICATIONS AND FEATURES Specifications • Power Requirements: (2) 9-volt batteries (not included) • Capacity: Approximately 220 paintballs • Feed Rate: 15bps+ • Construction: Composite
Features • Side mounting allows down-the-barrel sighting • Adjustable Speed setting • Auto-Off 1 Hour • Adjustable Sound Sensitivity • Low Battery Indicator • Auto anti-jam
Rip-Clip Installation • Loosen up the thumb nuts (Fig. B). • Install the Rip-Clip onto the marker’s Picatinny rail (Fig. C). • Check the position on the Picatinny rail and make sure the Rip-Clip is aligned with the feed hole on the side of the marker (Fig. D). • Tighten up the thumb nuts and you’re ready to go.
Extracted from the PDF. Read the full manual above, or download it.