Empire Magna Manual - English

Adjusting the Settings 6

Programming

Programming 7

Basic Operations

Attaching the RF transmitter to your marker 8

Adjusting the Magna Clutch drive cone force 8

Rip Drive™ 10

Magnet Plate 10

Disassembly

Disassembly of the loader 11

Installation

Drive cone installation 12

Deck installation 13

Reassembly

Reassembly of the Loader 14

Specifications

Specification 16

Warranty 2

Battery Installation

For best results, only use quality name brand batteries. when replacing batteries, used batteries should be recycled

No tools needed! Slide the battery door open. Remove the battery holder. Install batteries following the polarity markings of the battery holder. Connect power plug to battery pack. Re-install the battery pack with the battery connector sliding into the slot on the right side of shell (left side as you look at the loader from below). Slide the battery pack back in while keeping it as square as possible. If the battery pack is not installed correctly it might be difficult to remove. Finally slide the battery door closed. You may need to apply light pressure to the battery pack to allow the door to slide past it.

THE BATTERY HARNESS SLIDES INTO THE GROOVE SHOWN

can attach your Magna Drive loader to the markers feed neck Attaching the You or you may need an elbow to attach it properly. Loader The Magna Drive loader has a dual layer “laminated” feed neck for extra strength. The outside is part of the polycarbonate body shells and the inside is part of the nylon catch cup. This is the strongest loader feed neck design in paintball. The inside of the neck (the end of the catch cup) is intentionally designed to stick out further than the shell. This is to ensure no gaps in the feed path when the loader is used with a feed neck that has a conical bottom.