Tadao Ebisu Series AKA USB Board For the AKA Viking and Excalibur - English

Installation of the Ebisu board must be carefully done to avoid damaging the electronics or wiring harnesses. 1. Remove one grip panel from the side of the frame, and unplug the battery. 2. Remove the two screws that attach the frame to the gun body. 3. Gently pull the frame and tray away from the gun body. 4. Remove the 2 nylon screws that secure the board inside the tray. 5. Gently pull the stock board out of the tray and unplug all the wiring harnesses. 6. Plug all the wiring harnesses into the appropriate sockets on the Ebisu board. 7. Insert the Ebisu board back into the tray and install the two nylon screws. 8. Tuck all the wiring harnesses inside the tray and gun body, and then reattach the frame/tray with the two frame screws. 9. Replace the battery and grip panel. BOARD OPERATION Turn on the board by sliding the power switch to the on position. Turn off the board by sliding the power switch to the off position. The eye system is toggled on and off by pressing and holding the trigger for 3 seconds. The LED will reflect the eye status as it changes. The multicolor LED will display different colors based on which mode of operation the marker is in: Flickering Red – at boot time indicates an exhausted battery. Flickering Yellow – at boot time indicates a low battery.

Flickering Green – at boot time indicates a good battery. Solid Blue – eyes on, ball in breech, ready to fire. Slow Blinking Blue – eyes on, empty breech. Slow Blinking Red – eyes off. Slow Blinking Yellow – eye malfunction caused by the bolt not seen cycling. If used, the eye system cycles the marker as fast as possible. During each shot the eyes watch for the bolt to return, ending the current firing cycle and starting another as quickly as the pneumatics allow. If the eye system is continually blocked (e.g. putting your finger in front of the eyes) and is unable to see the bolt return after every shot, the max rate of fire will be reduced to prevent further chopping, and the LED will show an eye malfunction by slowly blinking yellow. Firing the marker with paint and air will utilize the eye system correctly, maximizing the rate of fire. USB Your Ebisu Series USB board has full USB 2.0 functionality, and works in tandem with the Tengu USB interface, which can be downloaded online at http://www.tadaotechnologies.com/productcart/pc/viewContent.asp?idpage=15. Tengu allows you to update the firmware on your board, modify all the settings, and more. To run the Tengu interface you need a mini-B USB cable and a PC running Windows 7, Vista, or XP. XP users will also need to download the Microsoft .NET Framework 2.0 or newer. Refer to the Tengu user guide for information regarding USB installation and using the Tengu USB interface. MENU SYSTEM The Ebisu series boards use a color coded menu system. Each setting has its own LED color and/or sequence assigned to it. To enter the menu system, hold down the trigger while turning the board on. The LED will show a rainbow sequence, followed by the last viewed setting. The tournament lock must be disabled in order to change settings on the board. Toggle the tournament lock by pushing the small switch located next to the LED. While the marker is turned on (but not in programming mode), push and hold the lock button. The LED will flash red or green to indicate the status of the lock. Red means the lock is on; green means the lock is off. When the lock and the marker are off, pull and hold the trigger, and turn the board on. The marker will boot into programming mode, showing a rainbow sequence before stopping at solid green. The board will remember the previously viewed setting after consecutive boots into programming mode. Pull and release the trigger quickly to scroll forward through the settings. When the last setting is reached, it will wrap around to the beginning. Green Purple Yellow Blue Red White Aqua Flickering Green Flickering Purple Flickering Yellow Flickering Blue Flickering Red Flickering White Flickering Aqua Double Blink Green Double Blink Purple Double Blink Yellow Double Blink Blue Double…