USE AND CARE INSTRUCTIONS for Paintball Vision System
ONE SIZE FITS ALL Fits adult size S/M/L
This product meets ASTM standards F 1776
NOT USE UNTIL ALL INSTRUCTIONS W A R N I N G DO REGARDING SAFETY HAVE BEEN READ.
WARNING Read and follow carefully the instructions and warnings contained in this manual. Failure to observe all instructions and warnings could lead to severe or permanent injuries. Note: This vision system cannot offer protection in all situations. ALWAYS wear your vision system when you are within or near an area where paintball markers are in use or when handling a paintball marker. NEVER remove or raise up your vision system in the playing area, even when lens gets dirty or fogs up. Should your vision system accidentally come off, protect your eyes immediately by getting to the ground, and covering your face with your hands. Inform all players to cease firing and request that a player or referee help you leave the playing area with your eyes covered. BEFORE the start of each game, all paintball markers must be chronographed ensuring that paintball speeds do not exceed 300 fps (91 m/s). Higher muzzle speeds can exceed resistance limits of the vision system, and can lead to serious or permanent injury. Do not play when paintball speeds are unverified or exceed recommended limits.
WARNING Before beginning a game test the Anti-Fog of your vision system’s lens by breathing on it’s inside surface. Should the lens fog up, treat with an approved anti-fog product or replace your lens.
VISION SYSTEM AND LENS CARE Your G.I.VISION System comes standard with a Single Pane polycarbonate lens which is treated with a Thermo-Cured, Anti-Fog and Anti-Scratch coating ensuring the very best performance and clarity. Dual Pane Thermal Lenses are also available as an aftermarket accessory or replacement Lens. This vision system protects from both 50cal and 68cal paintballs and offers basic head coverage. CLEANING YOUR VISION SYSTEM Always clean your lens within 2 hours of any contact with paintball markings. Remove lens to thoroughly clean all vision system surfaces. Use only warm water to clean the lens. Cleaning products may hinder and weaken lens. Replace lenses that come into contact with any chemicals or fumes. Use only clean soft cloths when cleaning lens. Avoid using other substances that can damage, scratch or dull your lens such as newspaper, paper towels, dish towels or clothing. When drying out your lens please note that the inside anti-fog will go through a tacky phase. This is normal and will stop once lens is completely dry. In order to clean this surface properly, it is recommended that you pat dry with a moist cloth and not wipe the inside as this will lead to streaking.
Extracted from the PDF. Read the full manual above, or download it.