Febuary 2023
NINJA MICRO FILL PANEL V3 OWNER’S MANUAL Part number: MICROFP
WARNING: This is not a toy. Misuse may
cause serious injury or death. Eye protection designed specifically for paintball must be worn by the user and persons within range. Recommend 18 years or older to purchase. Persons under 18 must have adult supervision. READ OWNERS MANUAL BEFORE USING. For more information visit www.NinjaPaintball.com or please call us at : (815) 477-0007
WARNING: ONLY FOR COMPRESSED AIR OR
NITROGEN.
WARNING: The fill panel is NOT a regulated
panel. The fill panel will deliver the pressure supplied to the input hose assembly. If you need to regulate the air supply source to 4500PSI or lower, we recommend you install the Ninja High Pressure Fill station between the air supply source and the Fill Panel. The fill panel has 1 micro hose assembly attached FILL HOSE WITH NON WHIP SAFETY FEMALE QD
The fill hose has the Ninja safety qd attached. This will help reduce the chance of hose whip by slowly draining the pressure if the male fitting is not secured. Even with this safety feature we recommend you always hold the fill hose when in use. START UP Secure the fill panel using the (4) holes in the base with appropriate screws. Attach the air supply source to the input JIC-4 fitting, DO NOT OVER TIGHTEN (see Figure 2.2 on page 2). For more information visit www.NinjaPaintball.com or please call us at : (815) 477-0007
WARNING: Do not exceed 4500 psi, the fill
panel is NOT regulated and will deliver the same pressure as the air supply source input. If you need to regulate the air supply source to 4500PSI or lower, we recommend you install the Ninja High Pressure Fill station between the air supply source and the Fill Panel. FILL PROCEDURE • Connect the air system to the Micro Fill Hose assembly QD. Make sure it is fully connected and the collar is closed. Do not force a male nipple into the qd! • Push and hold the button down to start the fill. • Release the button to vent. The venting of the unit will be under the micro fill panel body. • Wait for venting to stop. If it does not stop the male fill nipple on the tank you are filling could be not holding air properly. Once completely drained replace the male fill nipple and try filling again. • Disconnect the air system. If the unit leaks under use First check the (18) JIC-4 fitting for fill whip, during use these can loosen over time. Check the (8) gauge and gauge threads for leaks and replace the gauge if leaking. If the unit still leaks under use, replace the (11) 004-90 PU cast O-ring: For more information visit www.NinjaPaintball.com or please call us at : (815) 477-0007
Extracted from the PDF. Read the full manual above, or download it.