Ninja Fill Panel (Push Button) Manual - English

The fill panel has 1 micro hose assemblies attached. MICRO FILL HOSE WITH SAFETY Paintball Female QD START UP Secure the fill panel using the (4) holes in the base with appropriate screws. Attach the air supply source to the input JIC-4 fitting (see Figure 2.2 on page 2). Do not exceed 4500 psi, the fill panel is NOT regulated and will deliver the same pressure as the air supply source input. If you need to regulate the air supply source to 4500PSI or lower, we recommend you install the Ninja High Pressure Fill station between the air supply source and the Fill Panel.

FILL PROCEDURE:     

Connect the air system to the Micro Fill Hose assembly QD. Push and hold the button down to start the fill. Release the button to vent. Wait for venting to stop. Disconnect the air system.

Call Ninja @ 877-646-5287 for service.

Push Button Assembly: 1. High pressure plug 6. 010 Oring 11. Shaft

2. 012 Oring 7. Main Body 12. 010-90 Oring

3. High Pressure Spring 8. 004-90 PU cast Oring 13. Housing Nut

4. 0.25” ball 9. Oring Jam Nut 14. 015 Oring

5. High Pressure Seat 10. Return Spring 15. Retaining Nut

Figure 1

Maintenance: Figure 2 If the unit leaks under use: First check the JIC-4 fitting for fill whip and the gauge. During use these can loosen over time. F2.1 If the unit still leaks under use, replace the 8. 004-90 PU cast Oring : 1. REMOVE AIR SOURCE.

2. Using a 3/4” wrench, unscrew the 13. Housing Nut (F2.1) and remove the button/shaft assembly (F3.1). 3. Remove the 10. Return Spring (F3.1). 4. Using a 3/16” allen key preferrably WITHOUT a ball end, remove 9. Oring Jam Nut (F3.2). 5. Remove and replace the 8. 004-90 PU cast Oring (F3.3) 6. After replacing the 8. 004-90 PU cast Oring reinstall the 9. Oring Jam Nut snug to a hard stop using a 3/16” allen key.

Figure 3

7. Reinstall the 10. Return Spring by inserting the spring into the counterbore in the 9. Oring Jam Nut. 3.1

8. Grease the lower shaft with a silicone based oring lube and reinstall the button/shaft assembly (F3.1) by: Inserting the shaft through the 10. Return Spring and pass through the 9. Oring Jam Nut and 8. 004-90 PU cast Oring and threading the 13. Housing Nut (F2.1) back into the 7. Main Body.