SPIRE IV SETUP Thank you for purchasing the Virtue Spire IV™ paintball loader. This manual covers all aspects of your Spire IV loader. It is recommended you read the whole manual as it contains important product and safety information.
QUICK SETUP //
To start using the Spire IV immediately, install 3 AA batteries. The Spire IV loader can work either as a standalone loader or it can function in co-operation with an iFI supported paintball marker. For standalone operation simply turn loader on and start using it. For iFI pairing first turn on the marker then turn on the Spire IV while holding down the button on the bottom of the Spire IV. Keep holding the button until the LED indicators turn green, then release it. There will be a double beep to confirm pairing.
LENGTH:
HEIGHT:
WEIGHT:
BLUE, loaded and ready (Blinking BLUE while iFI paired) RED, not loaded, add paintballs (Blinking RED while iFI paired) YELLOW during startup, low battery. When your Spire IV starts with low batteries, it will automatically enter the power save mode until fresh batteries are installed. Power save mode prolongs battery life by shutting down Reload Indicator and LEDs. The LED will occasionally flash green to let you know it's on. GREEN blinking once every 2.5 seconds is in power save mode. When your Spire IV starts with low batteries, it will automatically enter the power save mode.
It is recommended to download the Virtue Paintball+ app from the Google Play Store or Apple App Store and download the latest firmware settings to your Spire IV.
CAPACITY: 230 balls BATTERIES: 3 x AA
WARNINGS \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\ * Always wear eye protection specifically designed for paintball. * Persons under 18 years of age should have adult supervision when using this product. * Only use projectiles designed for the sport of paintball such as paintballs or Reballs™. * Misuse of paintball equipment can cause serious injury or death.
SEE PROGRAMMING SECTION FOR ADDITIONAL SETTINGS
MANUAL // PAGE 1
BATTERIES + OPERATION BATTERY INSTALLATION // The Spire IV™ uses 3 AA batteries. To install them follow these steps: 1 Open top shell by pressing unlock button on the back 2 Remove Spire tray from shell by pinching the tray release tab between your thumb and forefinger and pulling the tray up. 3 Open Velcro strip covering the battery slots and insert 3 AA sized batteries. Follow the markings on the bottom of the battery holder for correct polarity alignment. Tighten Velcro over the batteries to ensure they don’t come loose during playing. Use high quality alkaline or lithium ion batteries. Using rechargeable batteries is not recommended and will cause performance issues. 4 Insert Spire tray back into the loader and push down until black lock clicks into locked position. 5 Close top shell by pushing it down until it locks in place.
SOUND // By default, the Spire IV sound is turned ON. To turn OFF the speaker, with the Spire on, simply hold in the Force Feed button for 2 seconds. To turn back ON, follow the same procedure and hold in the Force Feed button. The Spire will beep the number of times the Reload Indicator Alarm is set to confirm you have turned ON the Speaker. The Spire IV will remember your setting next time you turn on the Spire. MANUAL //
MANUAL // PAGE 2
Extracted from the PDF. Read the full manual above, or download it.