Tippmann Crossover XVR Supplement - English

Shortened Foregrip

Barrel Adapter for Autococker® threads

2 Piece Barrel with .692” Barrel Back

Available in multiple colors

Padded Carry and Storage Case, Part Number TA99051 The soft sided and internally padded case is designed to store and transport your marker safely. It provides an area for the marker, the two piece barrel, and has two stretch net pockets for accessories. Trigger Assembly, Part Number TA35112 Tippmann has redesigned the Crossover trigger to lighten the weight and decrease the trigger pull force, and still meet ASTM standards. The trigger has no field replaceable parts. Tool Less Bolt Removal End Cap Assembly, Part Number TA35146 The tool less bolt removal provides access to the marker’s internals without the need to use a tool. Push in on the center pin (arrow) while holding onto the knurled part of the knob. Pull backwards on the knob and the assembly pops out. Turn the knob counterclockwise to loosen the end cap assembly and gain access to the internals. To reassemble, insert internals and thread the end cap in until tight. Push the pin and end cap together towards the marker until the end cap is in its normal operating position. 1

Part No.

Tool Less Endcap Base

Pivot Pin

Spring

Tool Less Endcap Plunger

Ball Bearing Plug

Tool Less Endcap Knob

Normal Operating Position Shown

Description

Venting Regulator Assembly, Part Number TA35145 The venting regulator assembly allows the player to turn off and purge air to the gun without unscrewing the cylinder and reducing the life of the cylinder or Air Supply Adapter (ASA) threads. To attach your air cylinder, rotate the cylinder into the threads of the ASA part of the Regulator. To allow air into the marker, rotate the ON/OFF knurled surface in the counterclockwise direction. You will hear the marker gas up. Continue rotating the ON/OFF for an additional half turn for paintball play. Turning the knurled surface clockwise will shut off the air supply. Further turning in this 2

direction will purge air from the marker. If you wish, you can leave the cylinder attached for the next paintball event. See unloading instructions in your Crossover Owner’s Manual for additional information. To disassemble the Regulator, remove the cylinder from the ASA threads. Once the cylinder is removed, further clockwise rotation of the knurled surface will allow disassembly of the purge assembly. OFF / Purge / Disassemble

WARNING

Whenever performing maintenance, disassembling, or cleaning your marker, always fully remove the air cylinder. See your Crossover Owner’s Manual for detailed instructions.

Regulator Adjustment Cap

Poppet Housing

Regulator Piston Guide

Valve Housing

Regulator Spring Wear Disk

Cylinder O-Ring

Regulator Piston

Exhaust Pin

Threaded Pin Guide

Venting Regulator Body

Dowel Pin

Regulator Pin Seat

Glide Ring

Regulator Poppet

Valve Knob

ON / Pressurize