F E A T U R E S U P P L E M E N T FOR SL94 EGO
CONGRATULATIONS,
READ AND ADHERE STICTLY TO ALL OF THE SAFETY INSTRUCTIONS AND GUIDELINES IN THE EGO9 OPERATORS MANUAL!
04 SL SHAFT3 BARREL KIT 05 SL94 FIXED OUTPUT LPR 05 ZICK 2 RAMMER SYSTEM 06 ADDITIONAL TRIGGER SYSTEMS 07 FSD DELAY PARAMETER 07 CURE 3 BOLT SYSTEM 08 SERVICE HISTORY
Thank you for purchasing an SL-94 Ego marker. The SL range represents the very best of Eclipse in terms of cutting edge performance and technology that deliver on our philosophy of refined design and super fast markers that produce devastating firepower! I know you’ll be blown away with your new Eclipse SL-94, but before you use your Marker please read through this Feature Supplement as well as the Ego9 Operation Manual in its entirety and pay particular attention to all of the Warnings and Safety Guidelines. If you are missing either the Feature Supplement or the Ego9 Operational Manual both can be downloaded from the Downloads page at :
www.planeteclipse.com
At the back of this supplement is a section that will allow you to record and track your Markers Service History. If you have any questions or problems turn to the Dealers & Service Section in the Operation Manual where you will find a list of accredited Dealer Service Centres that will be able to help you out or of course you can always contact Nicky T in our Tech Support Department directly on:
JACK WOOD - CHIEF ENGINEER
SL94 FIXED OUTPUT LPR
NOTE: The bore size of your Shaft 3 may vary according To the model of SL you have.
Your Eclipse SL comes as standard with an Eclipse SL Shaft 3 barrel. The barrel screws into the body of the SL using a right hand thread meaning that if you hold the SL pointing away from you the barrel screws into the body in a counter-clockwise direction.
#010 NBR 70 LPR PISTON SPRING On the barrel back there is a 016 NBR 70 o-ring D which prevents the barrel from vibrating loose from the SL body when the marker is fired. There is also a 015 NBR 70 o-ring on the barrel front E helps with alignment when the two sections are screwed together.
FEATURE SUPPLEMENT
Replace and lubricate these o-rings with Eclipse Grease as necessary.
The barrel comprises of two parts, a barrel back A and a barrel front B . The two parts are joined together with a left hand thread meaning that if you hold the barrel, with the back nearest you, the front unscrews in a counter-clockwise direction. The bore size of the barrel back is engraved at the end of the barrel back C .
LPR CAP
Note: When installing the Fixed Output LPR Cap, DO NOT use the small LPR adjuster spring in the front of the piston from the Adjustable LPR Cap. Installing the small LPR spring into the front of the Fixed LPR Cap will cause the output pressure to drop too low and cause low and inconsistent velocities.
LPR PISTON
ZICK 2 RAMMER SYSTEM
ZICK 2 CAP
CUSHION
NOTE: The SL will only accept COCKER Threaded barrels. Do not use any other type of barrel thread.
BUMPER #009 NBR 70
SL SHAFT3 BARREL KIT
Extracted from the PDF. Read the full manual above, or download it.