Ver cal Pre‐set Regulator #1058 (FPT) and #1059 (ASA)
The regulator is pre‐set to 750 psi with a 6 disc stack. Normally you would not change the orienta on posi on of the discs as shown. Changing a disc from a series to parallel posi on increase output. If you flip the 1st and last disc the regulator will output 60 more psi (30 psi per disc orienta on change) however the input from the source must be greater than 800 + psi. Removing a disc will decrease pressure. For example if you remove the 1st or last disc the pressure will drop 300 psi which is not in the opera ng range of either the Phantom or Phantom Revolu on marker. 1.
Upper regular body #1060
Regulator piston #1065
Disc spring #1061
Retainer seat #1062
Base seal (factory sealed) #1064
Set screw 8‐32 #1091
Lower regulator body 1/8 FPT #1069
10. Lower regulator body ASA #1067
Extracted from the PDF. Read the full manual above, or download it.