MECHANICAL ADJUSTMENT
DETENT/VISION CLEANING – The Luxe® X Vision® anti-chop sensors and ball detents are housed under easily removed covers on either side of your marker. Simply slide the cover’s latch forward, and rock the cover forward to remove it. A cotton swab can be used to clean the electronic sensors, ball detents and the pass-through holes they use to access the breech.
07 TRIGGER ADJUSTMENT
Pre-Travel
Trigger Resistance
WARRANTY
Switch Activation
WARRANTY – Warranty Support and Service for DLX Technologies (DLX) products is provided by factory trained service technicians and DLX Authorized Service Locations. The DLX warranty is valid for one (1) year to initial retail purchaser. The warranty is limited to defects and workmanship in materials covering the paintball marker and regulator components. The electronic components and solenoid are warranted for six (6) months. Disposable parts (Batteries, O-Rings, Seals, etc.) are not warrantied. This warranty is effective only if the customer registers their marker online in our RMA system within 30 days of purchase. The warranty is non-transferable.This warranty is limited to repair or replacement of defective parts with the customer responsible for transporting the product to and from the Luxe® Paintball Authorized Service Location.
WARNING! – THIS IS NOT A TOY. MISUSE OF THE LUXE ® X MAY RESULT IN SERIOUS INJURY OR DEATH. EYE PROTECTION DESIGNED FOR PAINTBALL USE MUST BE WORN BY THE USER AND ANY PERSON WITHIN RANGE OF THE LUXE ® X. DLX RECOMMENDS THAT THE LUXE ® X ONLY BE SOLD TO PERSONS 18 AND OLDER. THOROUGHLY READ THE LUXE ® X QUICK START GUIDE BEFORE OPERATING.
LUXE X SETUP
Post-Travel
QUICK START GUIDE | V.03
TRIGGER ADJUSTMENT – Your Luxe® X features four-point trigger adjustment. Each of the four settings may be adjusted with a 1/16 inch hex key. Pre-Travel limits how far forward the trigger can swing. Post-Travel limits how far back the trigger can swing. Activation point adjusts how far into the pull the trigger switch is activated to fire your Luxe® X, and trigger resistance adjusts the strength of the magnetic field that resets the trigger. CAUTION – If the trigger is not adjusted to stop firmly on the PostTravel adjuster screw, permanent damage to the Luxe® X circuit board can occur from aggressive trigger pulls. {FIG. 07}
01 CHARGING
BATTERY – The lithium polymer battery in your Luxe® X must be fully charged before use. Lift the left side of the rubber grip away from the Luxe® X, un-tucking the tab from its slot at the top. Connect the USB Type C charging connector to the Luxe® X circuit board. Make certain the battery is fully seated in the grip frame. Once connected to the Luxe® X, plug the charger into a power outlet. The Luxe® X is compatible with standard USB and USB-C chargers, allowing it to be charged directly from a portable phone power pack, car USB power source, laptop computer or other USB compliant power supply. The battery may also be removed and charged separately with the optional Luxe® battery charger. Even if stored, the battery should be charged at least once every 6 months. {FIG. 01} The following three steps must be followed to ensure the Luxe® X battery is properly installed for reliable use: 1} Install the battery into its slot with the electrical terminals facing downward. 2} press downward on the battery when it is fully slid into the battery slot, locking it into position. 3} Insert the Battery Lock Pin all the way into the gap at the top of the battery slot until its tab rests against the front of the grip frame, locking the battery in place. {FIG. 02} WARNING! – Omitting the Battery Lock Pin may cause momentary power loss, turning off the Luxe X® after a jarring impact, such as when diving into a bunker. Always be sure to secure the battery with the Battery Lock Pin for uninterrupted operation on the field. {FIG. 02}
02 BATTERY
This warranty does not cover surface damages (scratches and nicks), misuse, or improper disassembly and reassembly. Attempts made to drill holes or remove metal from external surfaces could degrade the performance and/or safety of the marker and may only be preformed with written approval. The only authorized lubricant for the marker is GR33SE™ Lubricant. Use of any other lubricant could result in reduced performance and invalidation of the DLX warranty. Trigger alteration of any kind may result in serious injury, do NOT attempt to alter the trigger assembly in any way. Use of aftermarket components within the bolt system, trigger or other operational components voids any warranty on the modified assembly and its interacting systems. Removal of factory anodizing or other finish voids the warranty of any affected component as tolerances will be effected by such action. DLX strongly discourages use of aftermarket internal components as they may jeopardize the performance and/or safety of your paintball marker. Luxe® is a registered trademark owned by KEE Action Sports and used under license by DLX Technologies. Freak® is a registered trademark owned by KEE Action Sports and used under license by Philadelphia Americans, LLC.
WWW.LUXEPAINTBALL.COM
Orientation 1}Battery for Installation
2}Battery Lock Pin
Uninstalled
3}Battery Lock Pin Installed
DEGASSING - After use, remove the hopper and paintballs,then turn off your Luxe® X, secure the barrel blocker in place and turn off the ASA by swinging the ASA charging handle to its extended position. This will relieve air pressure between the ASA and vertical regulator, but, the Luxe® Power Core will still be charged with air. Relieve the internal pressure by pressing the bottom back of the quick-strip latch at the back of your marker. This will degas your Luxe® X and sound similar to opening a can of soda. Do not attempt to degas your Luxe® X while the ASA charging handle is in the charged position, as the continuous rush of gas will unseat an o-ring in the Luxe® X quick-strip system causing a leak. WARNING! – If the Luxe® Power Core is pulled out…
The first 1004 words, extracted from the PDF. Read the full manual above, or download it.