TIPPMANN
2955 Adams Center Road, Fort Wayne, IN 46803 USA P) 260-749-6022 • F) 260-749-6619 www.tippmann.com
CARVER ONE
Paintball Marker Owner’s Manual
WARNING THIS IS NOT A TOY. MISUSE MAY CAUSE SERIOUS INJURY OR DEATH. EYE, FACE, AND EAR PROTECTION DESIGNED FOR PAINTBALL MUST BE WORN BY THE USER AND ANY PERSON WITHIN RANGE. WE RECOMMEND YOU BE AT LEAST 18 YEARS OLD TO PURCHASE. PERSONS UNDER 18 MUST HAVE ADULT SUPERVISION WHEN USING THIS PRODUCT. READ THE OWNER’S MANUAL BEFORE USING THIS PRODUCT.
WARNING SAFETY IS YOUR RESPONSIBILITY READ AND FAMILIARIZE YOURSELF AND ANY OTHER USER OF THIS MARKER WITH THE SAFETY INSTRUCTIONS IN THIS MANUAL. FOLLOW THESE INSTRUCTIONS WHEN USING, WORKING ON, TRANSPORTING, OR STORING THIS MARKER. ALWAYS KEEP THE TRIGGER SAFETY IN SAFE MODE UNLESS IN A SHOOTING SITUATION, AS DETAILED IN TRIGGER SAFETY INSTRUCTIONS. ALWAYS KEEP THE BARREL SLEEVE INSTALLED WHEN NOT IN A SHOOTING SITUATION, SEE BARREL SLEEVE INSTRUCTIONS BELOW. Barrel Sleeve Installation Instructions 1. Insert the Barrel Sleeve onto the Barrel and loop the cord over the top of the receiver and position at the back of the grip as shown. 2. Adjust the cord length retainer up to the back of the grip by Barrel Sleeve pulling the cord through it until the retainer is snug against the back of the grip. Keeping the cord as tight as possible, leave just enough cord elasticity to pull the cord/retainer up over the top of the marker to remove the Barrel Sleeve for firing.
Cord Length Retainer
3. After the cord length is properly adjusted, lock the cord length by tying a knot in the cord against the back of the retainer as shown. 4. Before and after playing, inspect the Barrel Sleeve. Replace the Barrel Sleeve if the sleeve or cord is damaged, or a there is a loss of cord elasticity. 5. Clean the Barrel Sleeve with plain, warm water and store out of sunlight in a dry area when not in use.
Introduction CONGRATULATIONS on your purchase of your Tippmann® paintball marker. We believe our Carver One™ marker to be the most accurate and durable paintball marker available, and it is proudly manufactured by Tippmann. The Tippmann® Carver One marker will provide you many years of dependable service if cared for properly. Please take time to read this manual thoroughly and become familiar with your Tippmann® Carver One™ marker’s parts, operation, and safety precautions before you attempt to load or fire this marker. If you have a missing or broken part, or need assistance, please contact Tippmann Consumer Relations at 1-800-533-4831 for fast, friendly service.
Warning / Liability Statement This marker is classified as a dangerous weapon and is surrendered by Tippmann Sports, LLC with the understanding that the purchaser assumes all liability resulting from unsafe handling or any action that constitutes a violation of any applicable laws or regulations. Tippmann Sports, LLC shall not be liable for personal injury, loss of property or life resulting from the use of this weapon under any circumstances, including intentional, reckless, negligent or accidental discharges. All information contained in this manual is subject to change without notice. Tippmann Sports, LLC reserves the right to make changes and improvements to products without incurring any obligation to incorporate such improvements into products previously sold. If you as a user do not accept liability, Tippmann Sports, LLC requests you do not use a Tippmann Sports, LLC marker. By using this paintball marker you release Tippmann Sports, LLC of any and all liability associated with its use.
Safety Is Your Responsibility! Trigger Safety
WARNING
EXCEPT WHEN YOUR MARKER IS IN USE, ALWAYS MAKE SURE THAT THE TRIGGER SAFETY IS IN THE SAFE POSITION, (WHICH DISABLES THE TRIGGER) AND THAT THE BARREL SLEEVE IS PROPERLY INSTALLED (SEE BARREL SLEEVE INSTALLATION ABOVE). TO LOCK THE TRIGGER (SAFE POSITION): PUSH THE TRIGGER SAFETY IN FROM THE MARKER SIDE SHOWN ABOVE TO THE SAFE POSITION. TO UNLOCK THE TRIGGER (FIRE POSITION): PUSH THE TRIGGER SAFETY FROM THE OPPOSITE SIDE OF THE MARKER TO ENABLE FIRING. Familiarize Yourself with Safety... The ownership of this marker places upon you the total responsibility of its safe and lawful use. You must observe the same safety precautions as you would any firearm to assure the safety of not only yourself but everyone around you. Outlined here are some general precautions to be aware of. The user should at all times use caution and common sense when using this marker and always remember that the game of Paintball can only survive and grow if it remains SAFE! • Do not load or fire this marker until you have completely read this manual and are familiar with its safety features, mechanical operation, and handling characteristics. • Handle this and any marker as if it were loaded at all times. • Keep your finger off the Trigger until ready to shoot. • Do not look down the barrel of a paintball marker. Accidental discharge into the eyes may cause permanent injury or death. • Keep the Trigger Safety in the Safe position until ready to shoot (see Warning message above). • Keep a barrel sleeve installed on marker when not shooting (see Warning message above). • Never point the marker at anything you do not intend to shoot. • Never fire your marker at anything you do not intend to shoot because there may be paintballs or foreign debris lodged in the chamber, barrel, or the marker’s valve. • Do not shoot at fragile objects such as windows. • Never fire your marker at personal property of others. The paintball impact can cause damage and the paint can stain the finish of automobiles, houses, etc. • Always keep the barrel pointed down or in a safe direction, even if you stumble or fall. • Eye, face, and ear protection designed specifically to stop paintballs in the form of goggles and full face mask meeting ASTM Specification F 1776 must be worn by the user and any person within range.
The first 999 words, extracted from the PDF. Read the full manual above, or download it.