TIPPMANN
PRO/CARBINE BASIC PARTS LIST
INTERNAL VALVE PARTS NOT SHOWN: CA-27A Front Valve Seat Ca CA-27N Rear Valve Seat CA-29 Cup Seat CA-30N Valve Stem PA-28 Cup Seal PA-31A Valve Snap Ring PA-32 Valve Spring NOTE: Valve Disassembly is not recommended.
WARNING DO NOT DISASSEMBLE THIS MARKER WHILE IT IS PRESSURIZED WITH AIR. DO NOT PRESSURIZE A PARTIALLY ASSEMBLED MARKER.
NOT SHOWN: 4-PA Sling Swivel 5-PA Sling 5-PA1 Sling Keeper
Lower Receiver
Assembly Instructions
❏ Into the lower receiver halves; insert 4 grip nuts. ❏ Attach the 2 grips with ❏ 4 grip bolts. Into the right lower receiver insert ❏ trigger / sear and springs on ❏ 5 receiver dowel pins. ❏ Insert the 2 tank adapter nuts. ❏ Bolt the 2 halves together with 2 receiver bolts and nuts. ❏ Insert the safety with o-ring and ❏ secure with safety snap ring. ❏ Insert the 90 degree gas line fitting into the tank adapter and ❏ attach it to the bottom of lower receiver using 2 tank adapter bolts. ❏ Then attach the lower and upper receivers with 4 receiver connection bolts. ❏ Connect one end of the gas line (with teflon paste) to the 90 degree tank adapter fitting and ❏ attach the other end of the gas line (with teflon paste) to the upper receiver marker valve reduction fitting.
1-800-533-4831 • www.tippmann.com
Extracted from the PDF. Read the full manual above, or download it.