Evil Pimp Kit Ramping Board Manual - English

1) semi-auto bps adjustable (press the button all the way down)

(15 bps in PSP mode)

uncapped

green flashing

orange to green

12 bps 1 bps range of settings:

default = X3 ramp

3) X3 ramp mode, psp legal 15.4 bps limit (press the button all the way up)

*increment is how much it changes when you press the up or down button.

Reset Function

This allows the sensitivity of the EVIL® Pimp Kit’s trigger switch to be adjusted. The lower the number, the higher degree sensitivity. Some fields and tournaments are very strict about bounce and this allows you to customize your marker so it is always legal.

Electronic Trigger Sensitivity (ETS) - Green Flashing

increment*

This caps your maximum rate of fire with the eye on.

Rate Of Fire Adjustment Eye On (ROF) - Orange to Green

This ROF adjustment only affects the EVIL® Pimp Kit ™ when eye is off.

default

Rate Of Fire Adjustment Eye Off (ROF) - Orange Flashing

Your 7.0 Ghetto Board allows you to play in any league in the world by offering variable fire modes 1) Semi auto 2) X3 ramp mode after 4 trigger pulls - cap set by ROF Eye On 3) X3 ramp mode with 15.4 bps cap so it is PSP legal

Fire Mode - Red to Green

This delay allows the the paintball to fully seat in the chamber. Raise the BIP delay if you are using a slower hopper or having problems chopping or breaking paint.

Ball in Place Adjustment (BIP) - Red Flashing

Hold down the trigger and switch on the marker. Keep holding the trigger until the led changes from Orange to Red(4 seconds). If the led stays unlit then the EVIL® Pimp Kit ™ is locked–see Tournament Lock Section. You’re now in the settings menus and the marker should now be blinking Red. To cycle through the different options, pull the trigger. The led flashes a color to indicate the option selected. Red=Ball In Place, Red to Green=Mode of Fire, Orange=ROF (eye off), Orange to Green=ROF (eye on), Green=Electronic Trigger Sensitivity. Just hold down or press the up or down Dwell buttons located under the grip on the left side of the marker to change the setting of each option. Each time you press the Dwell button, the light should blink Green. The led glows Orange once any setting has been adjusted to its maximum or minimum. When you’re done changing all the settings, just turn the marker off and then on again and you’re ready to go.

Board Adjustments-Instructions for BIP, Fire Mode, ROF (eye off), ROF (eye on) and ETS

red to green orange flashing

Each time you press the Dwell button, the light should blink Green. The led glows Orange once any setting has been adjusted to its maximum or minimum.

Adjustable if marker is ON red flashing

Setting the Ghetto Board

Pimp Kit 7.0 Board Instructions

Dwell adjustment is how long the valve is held open. Higher Dwell usually leads to higher velocity. Dwell adjustment can be made in any live mode and it can be adjusted whether the Tournament Lock is on or off. The Dwell buttons are located directly on the left hand side of the board and are visible once the grips are removed. The upper button adjusts the Dwell up and the lower button takes the Dwell down.

Ball in Place Fire Mode Delay

Dwell Adjustment

ROF-eye off ROF-eye on

Dwell Down

LED Settings Menu Colors

Dwell Up

The Pimp Kit™ comes stock with the Tournament Lock on. Tournament Lock mode is toggled if both Dwell buttons are held when the power is turned on. The light will turn solid Green when the Tournament Lock is OFF. The light will turn solid Red when the Tournament Lock is ON. Once the Tournament Lock has been changed, the Pimp Kit™ must then be turned off and on again to adjust settings. The Tournament Lock must be turned off to adjust the BIP, Fire Mode, ROF, ETS or use the reset function.

Tournament Lock