USERS MANUAL
Manufactured by MacDev Paintball - Australia macdev.net
Tactical Drone Users Manual Copyright Mac Developments Pty. Ltd. 2009 All rights reserved No part of this document may be copied or reproduced in any form or by any means without the prior written consent of Mac Developments Pty. Ltd. Notice is hereby given that this manual is part of the article owned in whole by Mac Developments Pty. Ltd., known as indicated in this manual and drawings. All rights of manufacture and reproduction of such articles or any part thereof are reserved by Mac Developments Pty Ltd. Neither said article nor any part thereof may be manufactured or reproduced without the written authorization from Mac Developments Pty. Ltd. All proprietary rights and information are the sole property of Mac Developments Pty. Ltd. MacDev, Cyborg, Gladiator, Shift and Drone are all trademarks of Mac Developments Pty Ltd.
Statement of Liability Mac Developments Pty. Ltd. Makes no warranties with respect to this documentation and disclaims any implied warranties of merchantability or fitness for a particular purpose. The information in this document is subject to change without notice. Mac Developments Pty. Ltd. assumes no responsibility for its resale or safe handling. Mac Developments Pty. Ltd. assumes no responsibility for physical injury or property damage resulting from its use.
Caution! This is not a toy. Misuse may cause serious injury or death. Eye protection designed specifically for paintball must be worn by user and persons within range. Recommend 18 years or older to purchase. Persons under 18 must have adult supervision. READ USERS MANUAL CAREFULLY BEFORE USING THIS PRODUCT.
Contents Introduction quick setup Installing a preset air system Turning the air on and off Installing a loader Switching your Drone on and off Understanding the beam sensor Disabling the beam sensor Adjusting the velocity Replacing the battery
parts list programming your drone About the tourney lock Programming the software Debounce (Blue) Dwell (Red) Fire mode (White) Rate of fire - ROF (Green) Loader delay (Yellow) Anti mechanical bounce (Teal) Anti bolt stick (Purple) Ramp start (Flickering blue) Cycle filter (Flickering red) Eye mode (Flickering white) Bolt tracking delay (Flickering green) Test mode dwell (Flickering yellow) Resetting the software
maintenance Inline regulator Drivetrain
Introduction
Quick Setup Installing a preset air system Before installing a preset air system, loosen the venting ASA knob as shown. This will ensure that air supply is off. Screw the preset air system into the venting ASA. Turning the air on and off To turn the air onto your gun, screw the ASA knob all the way in as shown. NOTE: when you unscrew the ASA cap to turn the air off again, your marker usually stores one shot. Point the marker in a safe direction to fire off that shot before entering a safe area. Installing a loader Loosen the feed strap screw, then slide a loader into the feed tube. Ensure that the loader is pushed all the way to the bottom of the feed tube. Secure the loader in place using the feed strap screw. Switching your Drone on and off Turn your marker on by pushing the power button on your membrane pad. The indicator LED will show either solid red (no paintball loaded) or solid green (paintball loaded). The marker is now ready to fire. To turn your marker off, press and hold the power button until the indicator LED is extinguished. Understanding the beam sensor Your beam sensor allows your marker to detect if a paintball is correctly loaded.When your marker is turned on, your indicator LED will use colour to report the beam sensor status. The status reporting is: Red LED - no paintball loaded
Extracted from the PDF. Read the full manual above, or download it.