CO2 FILL STATION REBUILD INSTRUCTIONS
FOR THE SERVICE OF CO2 FILL STATION ITEM #40083
CO2 FILL STATION REBUILD INSTRUCTIONS THESE ARE INSTRUCTIONS TO SERVICE CO2 FILL STATION ITEM #40083
Your CO2 Fil Station has been designed to provide years of service, and repairs are rarely necessary. It is possible, however, that after extensive use you may observe minor leakage occurring. This is normally due to the particulate contamination typically found in liquid CO2 breaking down the seals.
ITEM 40086 SERVICE KIT CONTENTS:
2 X Valve Seals with “O” Rings 2 X Bottom Caps with “O” Rings 3 X Stem “O” Rings
Diagram 1
STEP 1 Remove the Fill Station from the CO2 tank. This service cannot be performed under pressure.
STEP 2 Unscrew the bottom caps using an allen wrench. Once these have been removed, you will be able to remove the internals. If the valves do not drop out, you can gently push them out from the top. Care should be taken not to scratch or damage the bore that guides the valve stems.
STEP 3 Install new service kit parts per Diagram 1. We recommend replacing all parts even if the original parts do not show any wear or damage. Caution: Be sure to install the correct spring size and stem length in the correct bore, reference Diagram 1.
STEP 4 Screw on the new bottom caps using an allen wrench.
Extracted from the PDF. Read the full manual above, or download it.